GMT FM45 Facemills
» Video: Product Spotlight on FM45 face mills| FM45 Cutter Bodies | ||||||
|
For general purpose facing and fine finishing, the GMT FM45 nickel-plated cutters are hard to beat. 20-degree positive inserts are held in 19-degree positive inclined pockets
for low-vibration cutting. Can be used on smaller machines thanks to the low horsepower requirements. Chip-thinning from the 45-degree lead angle allows increased feedrates by 50% over 90-degree cutters. Size ANSI SE43 (ISO SE 1204) square inserts maintain chip thinning to a cutting depth of 0.250". The chamfers on the inserts provide a wiper effect to minimize surface roughness. FM45-250
FM45-300
FM45-400
|
|
|||||
|
|
|||||
|
|
|||||
|
|
|||||
| FM45-250 |
FM45 Facemill - 2.5in (63mm) [ photo ]
|
Out of Stock * | ||||
| FM45-300 |
FM45 Facemill - 3in (80mm) [ photo ]
|
[ Add to Cart ]
 |
||||
| FM45-400 |
FM45 Facemill - 4in (100mm) [ photo ]
|
[ Add to Cart ]
|
||||
| Inserts for FM45 Facemills | |||||
|
Kennametal SEHW43 and Korloy SEHT43 carbide inserts with four cutting edges are available for FM45 facemills. SEHW43 Grade K2885 - General purpose grade, excellent for both roughing and finishing of steels and cast iron. Cemented carbide substrate is wear and impact resistant. Can be used with or without lubrication. (SEHW43A6T-K2885) SEHT43 Grade X83 - Uncoated, polished, and ground. These high-positive inserts feature razor sharp edges for maximum productivity in stainless steel, aluminum and other non-ferrous alloys. Coolant is recommended for cutting aluminum. (SEHT43AFFN-X83) |
|
||||
|
|||||
| SEHW43-K2885 |
Kennametal Inserts (pack of 5) [ photo ]
|
[ Add to Cart ]
|
|||
| SEHT43-X83 |
Korloy Inserts (pack of 10) [ photo ]
|
[ Add to Cart ]
|
|||